Freewing F14 Twin 80mm TrueFire and BlueFire LED Afterburner

Regular price $69.99


Unit is for EDF fan PN P0805 which is offered with the current version of the plane. 


TrueFire - Random flickering from 30% to 50% throttle to simulate the afterburner lighting/turning on. From 50% throttle to 100% throttle the afterburner gets brighter with full brightness at 100% throttle. 

BlueFire - Random blue led ring flickering from 30% throttle to 50% throttle. Center afterburner led is not on during this portion. From 50% throttle to 100% throttle the center afterburner led gets brighter with full brightness at 100% throttle. The blue led ring is on at a lower intensity during this portion. 

Select-A-Fire - adjust the throttle position where the main Orange LED turns on. For BlueFire units the throttle position where the Blue LED starts to flicker is adjustable. The ability to turn on and off the flickering effect is also provided. Available for TrueFire and BlueFire units. 

No additional radio (TX) programming is required to achieve the realistic afterburner effect. This is a plug and play system. 

Includes a 3D printed motor mount, 20" extension wiring from controller to LED, connection to a 6S battery balance port and receiver. We can offer a 4S version if desired. Just let us know. 

You will need to provide a Y cable from your ESC to receiver to accommodate the afterburner controller. We have them available as well for convenience.

The controller itself weighs 18g.

The dimension listed is for the outside diameter of the motor. The unit can be attached to the motor using a zip tie, Gorilla tape or FoamTac glue. See photos for more information. 

Installation instructions:

1) Remove the motor per the manual instructions. 

2) Attach the afterburner LED unit to the rear of the motor using FoamTac Glue. Tighten zip tie and add Gorilla tape if desired. Leave the FoamTac to set for 24 hours and then you can remove the zip tie if desired.  

3) Route the LED wire to the battery compartment.

4) Connect the LED wire to the TrueFire LED controller.

5) Connect the ESC lead to the Y splitter. One end goes to the receiver throttle port and one to the TrueFire LED controller Throttle connection. 

6) Connect the TrueFire LED controller Battery connector to the balance lead of the battery. 

7) Power on the plane and the transmitter. Make sure your plane is secure prior to adding throttle input. Give it throttle and enjoy the TrueFire! It gets really good around 30% throttle input. 


Customer Reviews

Based on 3 reviews Write a review

Customer Reviews

Based on 3 reviews
Very Awesome Blue Fire

These Afterburners are not cheap in price or quality. They are a little pricey but the overall money spend is worth the enhancement it attributes

Thank you Larry

F14 BlueFire afterbuner

Great communication from beginning to product delivery. Afterburner is amazing. Easy install. Exceeds expectation. Great price. Great quality

Thank you Larry.

Jonathan Holmes
Simply the best!

These AB units are some of the cheapest on the market - shipped quickly *and* have fantastic build quality. You're going to be hard pressed to find another system that's built as well as this is for the price. They will light up any model, even in the brightest sunlight. 5280's TrueFire units can't be beat for the price. Setup was fast and easy - 10 minutes tops.